Nieuwe Waterweg 10, 5347Js Oss (NL)


100% Phthalate free

As standard, we use phthalate-free black, yellow, red and fluorescent green material. All ingredients are individually FDA approved.

The dip moulding production starts after approval of the prototype. We find the most efficient manner of dip moulding to keep the costs low. Find out more below.

Mould production

The production process starts when the prototyping phase and the first prototype product have been successfully completed. In practice, the costs for a first run usually prove to be considerably lower than the costs for the prototype design. This is because the dip moulding program is specified during the creation of the prototype and thus production costs only depend on the material (use) and the hourly machine rate.


For contracts for large numbers of products, we will of course investigate the ideal ratio between the number of moulds and the number of times they must be dipped.

Corporate social responsibility in manner of production

The waste resulting from cutting and any rejected products are collected and recycled.